Cuda 10.5" Carbon Steel Hook Cutter
Out of stock
Item No.
18178
| Product Description $39.99
Cuda 10.5" Carbon Steel Hook Cutter is rated
out of
5 by
1.
- Corrosion resistant
- Carbon steel construction
- Cuda scale pattern, non-slip grip
- Full-tang construction
- Lifetime Warranty
At 10.5" length, the Cuda Hook Cutter will make short work of hooks lodged at any angle in your catch. The long handle construction of the cutter provides excellent leverage for hook cutting, and the carbon steel construction provides essential corrosion resistance. An integrated spring-action system further enhances the cutting power as well, expanding the breadth of cuttable hooks for these cutters considerably. Complete with the iconic Cuda scale pattern, non-slip grips and visible, full tang construction, the Cuda Hook Cutter is a must have for professional and amateur fishermen alike. Safety goggles are also recommended when using hook cutter, as cutting may result in sharp hook fragments moving at high velocities near the eyes.
Rated 5 out of
5
by
JCaldwell from
Cuts through anyhow like BUTTER
Highly recommend this hook cutter!! I haven't found a hook it won't cut. Bass Fishing hooks that is. Haven't tried any of the massive saltwater hooks. I have cut some heavy flipping hooks with no problem though. Must have took for the boat.
Date published: 2018-12-01
How do I get a refund?
Hi,
We do not offer refund but we do offer warranty replacement.
Thank You
Demaya
Date published: 2022-06-07
will these cutters rust? i use 1/0 and 2/0 jig hooks and aberdeen hooks for crappie, will these cutters fit into a crappies mouth?
Hi Ty,
Thanks for your question. The hook cutter is not fully resistant to rust, however, it should perform better than other tools when it is rinsed with fresh water, thoroughly dried and stored after each use. The cutters will fit into the mouth of crappie on the larger side but may not work with small crappie. Hope this information helps. Thanks for considering Cuda tools.
The Cuda Team
Date published: 2018-09-28
I use up to 9/0 gamu hooks, do you have anything to cut that siz e hook? Thanks
Hi Tommy,
Thanks for the question. We have successfully cut 9/O hooks in our testing but did not have consistent success so this hook cutter may or may not work for you. We generally claim we can cut up to 6/O hooks confidently. This would be the best tool we offer for this use. Hope this helps.
Regards,
The Cuda Team
Date published: 2018-09-05
Will these cut wire rope?
We found other products you might like!
- Cuda 6" Fillet Knife$88.99
Join Our Mailing List
Keep yourself up to date with special offers and events