At 10.5" length, the long handle construction of this tool provides excellent leverage for hook cutting. Corrosion-resistant carbon steel construction with spring -action. Cuda scale pattern, non-slip grips with full tang construction. Lifetime warranty. Safety goggles recommended when using hook cutter.
Cuts up to 6/0 Hooks
Corrosion Resistant Steel Construction
Spring-Action, Long Handles for Leverage
Handles Lock for Safe Storage
Watch in action:
bvseo_sdk, p_sdk, 3.2.0
CLOUD, getContent, 118.13ms
bvseo-msg: HTTP status code of 404 was returned;
will these cutters rust?
i use 1/0 and 2/0 jig hooks and aberdeen hooks for crappie, will these cutters fit into a crappies mouth?
Asked by: Ty Powell
Thanks for your question. The hook cutter is not fully resistant to rust, however, it should perform better than other tools when it is rinsed with fresh water, thoroughly dried and stored after each use. The cutters will fit into the mouth of crappie on the larger side but may not work with small crappie. Hope this information helps. Thanks for considering Cuda tools.
The Cuda Team
Answered by: The Cuda Team
Date published: 2018-08-27
I use up to 9/0 gamu hooks, do you have anything to cut that siz e hook?
Asked by: Tommy
Thanks for the question. We have successfully cut 9/O hooks in our testing but did not have consistent success so this hook cutter may or may not work for you. We generally claim we can cut up to 6/O hooks confidently. This would be the best tool we offer for this use. Hope this helps.
The Cuda Team